breadwithknifeMaking bread seems daunting, but it doesn’t have to be.  One of the steps with which you may be least familiar if you don’t make a lot of yeast products is proofing.

Proofing is simply putting the yeast dough in an environment to keep the yeast happy and alive.  There are two main factors in this: heat and humidity.

In well-equipped professional kitchens (unlike the one I work in) there is usually a proofer.  This is basically a metal box with a heating element and some sort of steam source (I’ve seen them as simple as a metal bowl sitting on the heating element).  These fancy things have both adjustable heat and humidity settings and in a professional setting are very useful.  However, let’s face it – they take up a lot of space and only do one thing, so most places go without.

The simplest way to proof unshaped dough is to place it in a greased bowl and cover with a moist towel.  This will work perfectly fine, but depending on the ambient temperature could take a while.  It also doesn’t work too well for shaped doughs such as loaves and baguettes.  The best solution I’ve found for the final proof of the shaped dough is to turn your oven into a proofer.

Keeping in mind that yeast dies at 140ºF, turn your oven onto the lowest setting it can be on.  This is often even before the numbers on the dial start showing anything – 100ºF works just fine.  Place a bowl (preferably metal) of warm water (not boiling) on the oven floor, and place the bread, on the tray you want to bake it on, above the bowl of water, allowing enough room for the steam to circulate.  Keep in mind that by the time it’s ready to bake the dough will have doubled in size, so don’t put the loaves too close together.  If your oven has a dodgy thermostat, as many do, check to make sure it isn’t too hot with an oven thermometer.

To test if it’s fully proofed, when the dough is roughly doubled, press your finger ever so gently onto it.  If it springs back, it still needs more time.  If it slowly springs back but leaves a bit of a dent, it’s ready to go.  Remove both the bread and the bowl from the oven, turn the temperature back up and bake away.

I’ve mentioned a few times working with custards baked in water baths like creme caramels or brulees. They aren’t anywhere near as complicated as they seem, but the depth of the water bath is important.

Too shallow a water bath and the custards will bake very fast, giving you only a small window when they are perfectly done. The water may also evaporate entirely, leaving uninsulated custard to bake with too much heat overcooking the edges before the centre is set.

Too deep a bath and your brulees will be in the oven until the cows come home, and you run the risk of water spilling into the custard at any point.

The best level to have the water is about 1/3 of the way up the side of the dish. Another trick is to place the ramekins in a small enough water bath that there isn’t too much surface area of just water, this will stop the water evaporating too fast.

© 2012 Culinary Tips Suffusion theme by Sayontan Sinha